I am a returning customer
Congratulations! Your new account has been successfully created!
You can now take advantage of member privileges to enhance your online shopping experience with us.
If you have ANY questions about the operation of this online shop, please e-mail the store owner.
A confirmation has been sent to the provided e-mail address. If you have not received it within the hour, please contact us.
You have been logged off your account. It is now safe to leave the computer.
Your shopping cart has been saved, the items inside it will be restored whenever you log back into your account.
Filtreco Sieve 5 Large – sieve filter for mechanical cleaning
Filtreco sieve filters are used as the first step for the mechanical filtration of large-sized debris and particulate matter such as plant leaves, fish waste, and leftovers. A mechanical filter is needed to minimize the load on the biolog..
Filtreco sieve filters are used as the first step for the mechanical filtration of large-sized debris and particulate matter such as plant leaves, fish waste, and leftovers. A mechanical filter is needed to minimize the load on the biological filter. Such filters provide the required level of mechanical cleaning of pond water from dirt and are relatively inexpensive. However, sieve filters require constant maintenance and inspection, the frequency of which depends on the level of water contamination.
Filtreco filters can be connected to both the skimmer and the bottom intake. This method of connection will help to ensure good circulation of water in the reservoir. Water is supplied to the filter grid at the same time by two pipes from the skimmer and from the bottom intake. It is best used to supply water with a diameter of 110 mm. Optimal filter performance is achieved when using such tubes. When installing the filter, it is recommended to install a tee with a connection directly to the sewer, so that if necessary, it can drain water with dirt directly into the sewer. If this is not possible, the pump can be used for this purpose. For optimal filter performance, a minimum of 17,000 liters per hour must be allowed to flow through the outlet, which will help prevent particulate matter from depositing on the outlet. But in practice, it is almost impossible to realize such a flow of water through the filter, so the possibility of access to different parts of the filter for washing and cleaning is realized. When solid, the large particles of dirt remain on it and the water flows freely. The filter mesh has a cell size of 300 microns, and for the last 5 centimeters the cell size is 200 microns. This size is optimal for filtering contamination and at the same time leaving nutrients in the water for beneficial pond bacteria. After passing through a sieve, water is usually fed into a biological filter, but in some cases it can be drained directly into the reservoir. A faucet is installed on the inlet pipe to block the water supply for filter maintenance. You can then wash off the dirt from the grid using a small amount of water. At the bottom of the filter grid there is a drainage hole for drainage of dirt, if necessary it can be connected directly to the sewer.
|Inlets:||3 to 110 mm|
|Вихідні отвори:||3 to 63 mm (male thread)|
|Дренажні отвори:||1 to 63 mm (male thread)|
|Продуктивність:||45 000 l/hour|
|Розмір фільтруючої панелі:||715 х 400 mm|
|Size (L*W*H) :||564х764х1006 mm|